A situation where the freezer is not working or there are problems with keeping the temperature at a certain level to ensure the contents are safe should and quickly be repaired. For troubleshooting, you can contact our Appliance Service Center. A major freezer breakdown is the lack of cold. Our experts at Reach-In Freezer Repair in San Diego County will perform quality repairs on your appliance.

Our company has been in the appliance repair market since 2001. Our staff includes Reach-In Freezer Repair and Service specialists with over 20 years of experience.

A weak freezer freezes for a variety of reasons – due to wear and tear, mechanical damage, or improper operating conditions. Sometimes the temperature increase is caused by long absence of defrosting or wrong settings. Contact our experts at Reach-In Freezer Repairs.

If your freezer is old and the sealing rubber has not been replaced, the door may not close tightly enough. Gradually, snow builds up on the walls of the freezer. Frost does not allow the door to close completely, the amount of heat inflows increases. It is desirable to replace the seal, but as a temporary measure will help to defrost the freezer. Service quality and in time will be carried out by technician Reach-In Freezer Repair and Service.

Widespread breakdowns

If there is no ice in the freezer and the regulator is in the correct position, you will need the help of a Reach-In Freezer Repair technician. He will perform a freezer diagnostic, visual inspection, and the use of a specialized tool to determine the cause of the rising temperature. The most common problems encountered are the following.

Compressor

The freezer compressor could have malfunctioned. The motor starts only for a few seconds and then shuts down. It happens because of natural wear and tear or excessive load.

Thermostat

For electromechanical models, operation of the unit with long pauses is typical for problems with the thermostat. No temperature data is received, no switching to freezer cooling takes place. The broken part is replaced.

Switching valve

Freezer freezes, but not enough. The valve is stuck in the position of simultaneous cooling of the freezer and cooler compartment. Unit does not have enough power. The valve needs to be replaced. The technician at Reach-In Freezer Repairs and Services will replace this part, in no time at all.

Freon leaking through a steel circuit

Freezers with a weeping evaporator, bottom of the freezer compartment are prone to the problem. Clogging of drainage holes leads to water accumulation under the drawers for vegetables and fruits. Moisture drains to the front and top of the freezer, through microcracks in the plastic gets to the metal circuit, causing corrosion, damage to the integrity.

Freon escapes through small holes. It is necessary to seal and refill the freezer with the refrigerant. Our company has qualified Reach-In Freezer Repair technicians who will fix this malfunction.

Mechanical damage

If the freezer stopped working after defrosting using a sharp object to break up the ice, it is possible that the refrigeration circuit has been damaged.

Control module

Freezer compartment does not work, no additional problems observed. Probably the electronic control board has malfunctioned. It is being re-flashed or replaced.

It is not recommended to try to determine and eliminate the cause of the freezer malfunction yourself. Repair requires original parts, professional repair, and diagnostic equipment. If you have any problems with the operation of your freezer, just leave a request at our Appliance Service Center. The specialists at Reach-In Freezer Repair and Service will quickly perform all necessary work and make recommendations regarding the further operation of your freezer.