Wine coolers are a worthy and profitable alternative for storing expensive wine brands in conditions that correspond to the premises of wine coolers. In the event of a structural failure, you need to have your wine coolers repaired immediately. It’s best to contact the proven professionals at Appliance Service Center right away to perform service. Our professionals at Wine Cooler Repair in Santee, CA recommend having ongoing service that will extend its life significantly.

As the masters of Santee Wine Cooler Repair point out, it is a good idea to periodically perform maintenance and diagnostics, this will allow us to identify the problem in time, to fix the problem. In most cases masters encounter the following malfunctions and breakdowns.

Control module breakage

How correctly it works and will depend in the future on the very work of the entire wine cooler, and because of power surges – it can burn out. So, to prevent the breakdown of the control board, simply connect the stabilizer.

On the breakdown of this part will indicate:

• The electronic display goes out – it can be not only a lack of electricity in the network, but the breakdown of one or another sensor.
• The equipment fails to work and does not set the proper temperature that was set during setup and operation.
• This or that error code appears on the display.
• In some cases, you just need to reflash it, but in case of a serious failure it will be replaced. Wine Cooler Repair in Santee, CA will perform the replacement parts.

Compressor

There is also a high chance of damage to the motor itself. Pistons and piston rings can wear out because of backlash. If the sound appeared recently – then the engine can be repaired. If you waited quite a long time and went to the master at the last moment – then the engine will have to be replaced. In the case of severe wear there is decompression, which does not allow you to restore the device. Santee Wine Cooler Repairs will charge the system with freon when you contact us.

High indoor temperatures

The most recent option is high indoor temperatures. Even though the operation of the compressor model is almost independent of the ambient temperature, these devices cannot function properly in high heat or direct sunlight. If you find a manual for the cabinet, it will indicate its temperature class, according to which it can operate only in a certain temperature range. Our technicians specializing in Wine Cooler Repair in Santee, CA will make recommendations for the room.

The higher the ambient temperature, the less efficiently the condenser (the grill on the back of any refrigerator) performs cooling. In this case, the compressor must work much harder than it normally does, which can be perceived as noise. Further operation of the unit in these conditions is not recommended. In case of prolonged operation, it may completely shut down or even burn out. Santee Wine Cooler Repair specialists will make a diagnosis and solve the problem on site at the owner.

Fan problems

The fan is necessary to allow air circulation inside the chamber. Without it, cooling will not be uniform and the whole point of the wine cooler will be lost. Like any mechanical device, the fan can fail. Its damage can be compared to a computer cooler, which, after the motor bearings wear out, begins to make a strong hum or even a metallic clatter.  Our company has specialists in Wine Cooler Repair in Santee, CA who will perform the replacement fan.

This equipment belongs to a rather specific category, because of which only Appliance Service Center professionals can repair wine cabinets. Therefore, if you need wine cooler repair, when contacting the chosen repair shop, you need to ask the professional in advance if they can do Santee Wine Cooler Repair and Service.