Ice makers are special machines for producing ice, which are widely used in the catering industry. Repairing complex equipment by your own efforts rarely leads to a positive result, so we recommend that you contact the specialists of Appliance Service Center right away.  Our staff is made up of top-notch professionals. We perform quality Frigidaire Ice Maker Repair in San Diego County. We can also come to a manufacturing facility, store, or any other location for ice maker repair.

Our service center is staffed by Frigidaire Ice Maker Repair and Service technicians with over 20 years of experience. Our company has been repairing appliances since 2001.

Ice maker malfunctions

Drain hose or drain clogged

The principle of connection and operation of the drain hose in an ice maker is similar to a washing machine, but clogging occurs much more often. At the same time, you may notice water and non-freezing cubes inside the chamber. Frigidaire Ice Maker Repairs will do the hose cleaning work. Contact them by calling the phone numbers posted on our website.

Evaporator thermostat

It signals the temperature in the chamber to the module. To check it, press the spring of the part from the back of the unit. If you need the thermostat replaced, contact the Frigidaire Ice Maker Repair and Service technicians.

Solenoid valve

The valve shuts off the flow of refrigerant into the evaporator to freeze the liquid. It opens before starting the defrost, allowing hot flow into the evaporator. A current is applied to the defrost coils to check if it opens or not. A resistance is measured on the defrost coil. You can contact our company. We have qualified Frigidaire Ice Maker Repair technicians who will fix this problem.

Opaque cubes are produced

This happens when using hard water, which contains a lot of lime and calcium. If your area has a lot of impurities, be sure to install a purification filter.

Switch failure

If the ice maker does not turn on or shuts off after 15 minutes of operation, the hopper thermostat is probably defective. No ice will be made, or the pressure switch will trip in an emergency mode. The hopper thermostat is used to control the ice production. As soon as the temperature in the chamber reaches a certain point, the unit is disconnected from the mains.

Evaporator does not freeze

Pressure is higher than normal during suction. Water or solenoid valves may be open. Check and replace elements.

Evaporator not freezing properly

The pressure is probably lower than normal. This happens as a result of capillary blockage or coolant leakage. The blockage must be found and repaired, and the condition of the filter-drier must be checked. Eliminate the leak and charge the system with refrigerant. Frigidaire Ice Maker Repairs and Services refrigeration technicians fill the evaporator with coolant.

Ice takes longer to produce than usual

If the cycle lasts longer than half an hour, half of the cubes are irregularly shaped. It means that the radiator is clogged (relevant for air-cooled generators). The radiator needs to be cleaned as a matter of urgency. We have Frigidaire Ice Maker Repair specialists who will do the service, when you contact us.

Noisy operation of the unit

When you hear noise and whistling while the generator is running, the condenser micrometer is probably worn out. It is not recommended to lubricate and repair it. it is better to replace it immediately.

If you have noticed the above problems, then contact our Appliance Service Center technicians, who will solve them quickly and competently. The master will arrive at the place, will inspect the ice maker and will identify the exact problem together with its cause of occurrence, will make repairs and will issue a warranty. You can be sure that after our Frigidaire Ice Maker Repair and Service-related ice maker repair services, your equipment will work for as long as possible without any even the smallest breakdowns.