In recent times, it is difficult to find a home without additional ventilation devices, as they not only make cooking easier and more enjoyable, but also do not require much care and attention from homeowners. If the installation of the kitchen hood is done correctly, the only thing to pay attention to during operation is the regular change of clogged filters. You don’t need to waste your energy on repairs, but you should contact our company Appliance Service Center. For fast repairs, our company provides quality Awoco Hood Repair in San Diego County. 

The most common problems are

The hood does not turn on

If when you try to turn on your hood, the backlight does not work and the fan does not turn on at all, you need to check for voltage in the outlet. It is also necessary to check the serviceability of the power plug of the hood and the integrity of the cord. Next, check the motor winding and the contact pads of the switch.

The contacts can oxidize if used for a long time, especially considering that the hood is constantly working in a high humidity environment. Contact us for Awoco Hood Repair and Service.

Appliance won’t shut off

If your hood was working fine and then suddenly stops turning off, the first thing to do is to clean the control panel. Accumulated grease or food residue can block the switch. To fix the problem, you need to clean the surface with a sponge and a small brush. Sometimes manufacturers equip hoods with a special protection that locks the control. Grease or foreign objects can clog this protection, preventing the switch from turning off. If you can’t fix the problem yourself, contact Awoco Hood Repairs.

Fan speeds don’t switch

Speed switching in modern fume hoods is done with buttons, slide switches, or sensors. If there is a problem with the fan speed changeover, the control buttons, control box or control board should be checked for proper operation. When inspecting the buttons, visually or with a gauge, assess the continuity of the wire from the button to the motor and the condition of the contacts. Awoco Hood Repair and Service will fix this problem.

Fan is humming too much

Excessive hood noise can be due to poor workmanship of the unit and sloppy installation of the air exhaust duct. Inexpensive cooker hoods are often poorly constructed. In such models, even the slightest backlash will cause a strong vibration, creating noise and hum when the motor is running. Awoco Hood Repair technicians will come to you and fix the problem.

Decreased suction power

If your hood’s suction power decreases, the first thing to check is the condition of the appliance’s filters, especially the grease trap. You can diagnose the problem more accurately by checking the hood without filters. The draft rate must be checked briefly after switching on the appliance with the filters removed. 

If it is normal, then the grease trap filter must be cleaned and the carbon filter replaced if fitted. Also, a clogged exhaust vent in the house may be the cause of a bad draft in the exhaust mode. When you contact us, our Awoco Hood Repairs and Services experts will fix the problem. 

The lights are not working

When there is no light, the first thing to check is the condition of the light bulb and its socket. You can differentiate the malfunction by screwing a known good bulb into the socket. You should also check the serviceability of the control that is responsible for turning on the light and the wires that lead to the elements of lighting. Awoco Hood Repair electrical technicians will fix the problem.

Unpleasant odor from the hood

The cause of unpleasant odor from the hood is most often caused by a back draft. It occurs when the pressure inside the room is lower than that outside. This can occur if there is no fresh air supply into the room or if the ventilation duct cross section is restricted. To a large extent to prevent the suction of air from the ventilation shaft can install a check valve that allows air in one direction and closes the section of the duct at the reverse air flow.

Independent repair of the hood is possible only in the case of uncomplicated faults. As a rule, such work is limited to replacing a blown bulb or cleaning and replacing filters. Repairs involving diagnosis and replacement of electrical components are best left to the professionals at Appliance Service Center. Masters are familiar with the design of different models of exhaust units, the peculiarities of mountings. Contact only experienced professionals for Awoco Hood Repair and Service.