Now, the first thing that you need to understand is that a broken washing machine definitely means quite a lot of issues. While the machines might actually seem quite discouraging, a lot of people are trying to handle them on their own. With this in mind, we’ve taken it upon ourselves to provide you with a quick few steps to resolve one of the most common issues. It might cause your washing machine to fail at performing one of the most important internal tasks – to spin. If you are wondering about the main designation of the spinning – it’s done in order to prevent the clothes form soaking as this could damage them significantly. Now, it’s also important to understand that there are a few components which might have gone bad and need repairing or replacement when it comes to the integrity of the spin cycles. Let’s have a look.

Direct drive motor coupling

In some cases, top load washers are going to use direct drive motor coupling in order to transfer the power from the motor to the actual transmission. In situations of the kind, the coupling is the component which actually connects the motor to the transmission – it usually consists of two plastic drive forks which have rubber coupling in between. If your machine fails to drain, it’s also likely that it fails to spin properly and you are likely to have an issue with your direct drive motor coupling.

Door lock and the interlock

These are also components which you need to check conveniently. Now, usually, there is a safety mechanism which is installed on the front-loading washing machines. However, certain top loaders also have it. If your machine doesn’t spin, it might be a malfunctioning locking mechanism. If the lock has failed, it’s not going to send the correct signals to the motor and the latter won’t start the spin cycle.

Wax motor

Some front loading models use wax motors which are designed to engage the door lock assembly. If it’s failing, this could be the source of your issues. Check the entire thing for continuity with a regular multi-meter. You should be getting a resistance of an approximately 1500 to 1900 ohms and if the motor is showing open then you are likely to have a defective circuit. In any case, these are some of the issues which might be the cause for a failed spin cycle. This is not something that you can afford to have as it’s going to ruin your clothes – the spin is a very important part of the entire process and you need to take it into proper consideration at all cost. It is best to call in the professional technicians for appliance repair and ensure that they handle it well. Usually your local appliance repair service will send over expert technicians to fix the washer after they evaluate it properly. Contact us:

(619) 719-5005

[email protected]